Approximately 60% of emissions from an uncontrolled vehicle engine come from the exhaust - a result of combustion of the fuel and the air.
It is a regulated requirement to reduce these emissions. Some vehicles use devices or systems that control the combustion process itself, while others treat the resulting exhaust gases.
Both Fuel injected and Carbureted engines meet emission standards by maintaining accurate mixture control over a full range of engine conditions. To achieve this, most fuel systems require an air supply at constant temperature.
In some cases a heated air-inlet system uses hot air collected from near the exhaust manifold, and mixes it with outside air.
One simple control system uses a temperature-sensitive valve inside the air cleaner. It operates a flap that blends the hot air with cool air, so that the intake and fuel delivery mechanism receives air at 104 degrees Fahrenheit or about forty degrees Celsius, regardless of outside air temperature. Maintenance of this temperature assists vaporization of the fuel, particularly when the engine is cold.
Vaporization is also assisted by heating the intake manifold, normally by circulating hot liquid coolant through passages in the manifold.
If a manifold is too cold, fuel condenses on its inner surfaces, which will create a lean mixture, and may cause incomplete combustion. Carbon monoxide and hydrocarbon emissions are highest from a cold engine.
Changes in operating conditions can change mixture-conditions within the manifold. For instance; if a carburetted engine is being driven at moderate speed, and the throttle is suddenly closed, any fuel condensed on the manifold walls is drawn into the cylinders.
The low pressure in the manifold also acts on the idle circuit in the carburetter, to cause a larger amount of fuel to flow from the idle discharge port. All of these factors enrich the mixture entering the engine.
There is only a relatively small quantity of mixture in the combustion chamber at this point, so turbulence tends to be poor. This can lead to incomplete combustion, and the release of unburned gases into the exhaust.
To reduce this effect the throttle positioner and dashpot slow down the rate of closure of the throttle plate. This allows more time for air to enter the manifold, and for the fuel to vaporize, before the throttle is completely closed.
A more combustible mixture is thus formed, which leads to complete combustion, and a reduction in hydrocarbon and carbon monoxide emissions.
Electronically managed fuel injection systems use sensors and catalytic converters to control the combustion process and the air-fuel ratio supplied to the engine at all times. To see how this is achieved see the feedback & looping section of this textbook.
Source: CDX Global
