The ABS controls braking forces by controlling the vehicle's brake system hydraulic pressure to prevent the road wheels from locking up during heavy braking forces. The braking force is controlled by a combination of factors. These include:
During normal braking, as the rotational speed of the wheel falls, no electric current flows from the ECU to the hydraulic unit. The solenoid valve is not energised. The brake master cylinder hydraulic pressure is applied to the brake unit, and the ABS is not involved. However, even though the ABS is passive during normal braking, its control module is constantly monitoring for rapid deceleration of any of the wheels.
If a wheel-speed sensor signals severe wheel deceleration - which means the wheel is likely to lock up - the ECU sends a current to the hydraulic unit. This energises the solenoid valve. The action of the valve isolates the brake circuit from the master cylinder. This stops the braking pressure at that wheel from rising, and keeps it constant.
If the sensors signal the wheel is still decelerating too rapidly, the ECU sends a larger current to the hydraulic unit. The armature moves even further and opens the valve. It opens a passage from the brake circuit. Brake fluid is sent from the brake circuit back to the master cylinder. Pressure in the brake caliper circuit is reduced so that the wheel is braked less heavily.
If the wheel sensors indicate that lowering the brake pressure is letting the wheel accelerate again, the ECU stops sending current to the hydraulic unit and de-energizes the solenoid valve. This lets the pressure increase, so that the wheel is again decelerated.
This cycle repeats itself about 4 to 6 times per second.
It is normal in an ABS for the valves in the hydraulic control unit to keep changing position as they change the brake pressure that’s being applied. These changes in position may cause rapid pulsations to be felt through the brake pedal.
Source: CDX Global & Wikipedia - en.wikipedia.org
